Camera Hardware Interface; Installation Overview; Input/Output Connectors And Led - Dalsa Piranha 3 Series User Manual

Piranha 3 User Manual
Camera Hardware
Interface

2.1 Installation Overview

When setting u p you r cam era, you shou ld take these steps:
1.
This installation
overview assumes you
2.
have not installed any
system components yet.
3.
4.
5.
6.
7.
8.
You m u st also set u p the other com ponents of you r system , inclu d ing light sou rces,
cam era m ou nts, host com pu ters, optics, encod ers, an d so on.

2.2 Input/Output Connectors and LED

The cam era u ses a:
•
•
•
Teledyne DALSA
All manuals and user guides at all-guides.com
Pow er d ow n all equ ipm ent.
Follow ing the m anu factu rer's instru ctions, install the fram e grabber (if applicable). Be
su re to observe all static precau tions.
Install any necessary im aging softw are.
Before connecting pow er to the cam era, test all pow er su pplies. Ensu re that all the
correct voltages are present at the cam era end of the pow er. Pow er su pplies m u st
m eet the requ irem ents d efined in section 2.2.2 Pow er Connector.
Inspect all cables and connectors prior to installation. Do not u se d am aged cables or
connectors or the cam era m ay be d am aged .
Connect Cam era Link and pow er cables.
After connecting cables, apply pow er to the cam era.
Check the d iagnostic LED. See 2.2.1 LED Statu s Ind icator for an LED d escription.
Diagnostic LED for m onitoring the cam era. See LED Statu s Ind icator in section 2.2.1
LED Statu s Ind icator for d etails.
6-pin H irose connector for pow er. Refer to section 2.2.2 Pow er Connector for d etails.
H igh-d ensity 26-pin MDR26 connector for Cam era Link control signals, d ata signals,
and serial com m u nications. Refer to section
15
2
03-032-10216-06