Dalsa Stop Action 4M30 User Manual page 30

30
Related Com
Example:
Ta ble 12: Line Time and Frame Readout Time when using a Window of Interest
To calculate frame readout time when using a window of interest, u
formula:
Frame Readout Time= Number of Lines x Line Time where Numbe
number
number of lines by sending the
Refer to section 3.5 Setting a Vertical W
sett
Setting
P urpose:
Syntax:
Syntax Elem
Related Commands:
Example:
Notes:
Figure 17: Detailed Timing Requirements for Hardware Triggering New Window Sequence
Window S elect (CC4)
Table 13: Timing Parameters
Symbol
03-32-10121-09
PRELIMINARY
always set to
y2
Window end pixel number in range from
belong to the following set: 4, 8, 12, ...1728.
mands:
wss,
wse 0 1 1 13 2352 544
of lines from all windows from the current sequence. You can retrieve the
ing windo w
the Window Sequence
To allow quick activation of new window coordinates, the camera
allows you to preset one sequence of window coordinates. These
coordinates wait for a trigger and because they have been
preprogrammed, the new window is activa
This command sets the control method for
seq uences
wts i
ents:
i
1
2
wss
wts 2
•
•
E XS YNC
Definition
.
2352
wts
command
gcp
indow of Interest for more information on the
.
New window sequence is triggered through software
command .
wss
New window sequence is triggered throu
inputs (CC4).
If you are using a hardware trigger (wts = 2), refer to Figure
17 for timing requirements.
If you are using a software trigger, refer to the next section for
command syntax and timing requirements.
tsWLE V
New Window S equence
4M Stop Action Camera Manual
- and must
2 1728
se the following
r of Lines is the total
ted extremely quickly.
toggling window
gh Camera Link
thWLE V
Min Max
DALSA