Appendix E Installing Windows Server 2003; Before Installing Windows Server 2003; Optional Board Supported By Nec Expressbuilder; Installing Service Pack - NEC N8100-1223F User Manual

Appendix E
Installing Windows Server 2003
This section describes the procedures for installing Windows Server 2003 without using Express
Setup tool.

BEFORE INSTALLING Windows Server 2003

Please read carefully the following information BEFORE commencing your Windows Server 2003
Installation.

Optional Board Supported by NEC EXPRESSBUILDER

NEC EXPRESSBUILDER CD-ROM attached to your system supports the following optional
boards:
NOTE:
disk ("OEM-FD for Mass storage device") except ones listed below, see
"Exceptional setup" and "Installing Optional Mass Storage Driver" of
"Configuration Diskette Creator" in Chapter 6.
Supporting installation of OS in NEC EXPRESSBUILDER
– LSI Logic MegaRAID SAS PCI EXPRESS ROMB (Controller on the I/O board)
Other optional boards
– N8103-81F Disk Array Controller (SCSI 2ch)
– N8103-75 SCSI Controller
– N8103-95 SCSI Controller
– N8190-126 SCSI Controller

Installing Service Pack

You can install the Service Pack on the server. When the Service Pack is not attached to your system,
prepare it by yourself.
When using Windows Server 2003 with this equipment, surely apply ServicePack 1.
When installing Windows Server 2003 R2, it is not necessary to apply Service Pack 1.
If you want to install the other boards by using a driver floppy