Table of Contents
Advertisement
4.
Unlock the memory board to open the ejector.
The memory board becomes very hot while being powered. When removing the board,
turn off the power and wait for several minutes before pulling it out.
Note that the hot-plug memory board is off-powered when it is unlocked (the LED goes
off). Wait several minutes in this state.
5.
Hold the ejector and pull the memory board out from the server.
6.
Put the memory board on a dry, clean, and static-free place.
Installation
Install the memory board in reverse order of the removal steps.
Upgrading Your Server 9-51
Advertisement
Table of Contents
Troubleshooting
