NEC N8100-1223F User Manual page 317

Error
Error message
code
0B94 IPMB signal lines do not respond.
0B95 BMC FRU device failure.
0B96 BMC SDR Repository failure.
0B97 BMC SEL device failure.
0B98 BMC RAM test error.
0B99 BMC Fatal hardware error.
0B9A BMC not responding.
0B9B Private I2C bus not responding.
0B9C BMC internal exception.
0B9D BMC A/D timeout error.
0B9E SDR repository corrupt.
0B9F SEL corrupt.
0BB0 SMBIOS - SROM data read error.
0BB1 SMBIOS - SROM data checksum bad.
0BC0 POST detected startup failure of 1st
Processor.
POST detected startup failure of 2nd
0BC1
Processor.
0BC2 POST detected startup failure of 3rd
Processor.
0BC3 POST detected startup failure of 4th
Processor.
8120 Unsupported DIMM detected in DIMM
group #1.
8121 Unsupported DIMM detected in DIMM
group #2.
8122 Unsupported DIMM detected in DIMM
group #3.
8123 Unsupported DIMM detected in DIMM
group #4.
8124 Unsupported DIMM detected in DIMM
group #5.
8125 Unsupported DIMM detected in DIMM
group #6.
8126 Unsupported DIMM detected in DIMM
group #7.
8127 Unsupported DIMM detected in DIMM
group #8.
Troubleshooting 8-23
Recommended Action
All the functions other than the function of
accessing to SMC through IPMB can be used.
This is not a fatal error. Turn off the power
once and then on again to restart the server. If
the error cannot be corrected, contact your
service representative.
All the commands and functions other than the
FRU command and the EMP function can be
used. This is not a fatal error. Turn off the
power once and then on again to restart the
server. If the error cannot be corrected,
contact your service representative.
Turn off the power once and then on again to
start the server. If the error cannot be
corrected, contact your service representative.
Contact your service representative.
Contact your service representative to replace
the processor.
Contact your service representative to replace
the two DIMMs in the relevant group.