List Of Alarms; Modifying A Trunk Configuration - Avaya G860 Installing And Operating

Avaya G860 Media Gateway
19.1.3

Modifying a Trunk Configuration

For a detailed description of the configuration methodology and detailed trunk
parameters, refer to the Programmer's User Manual, Document#: LTRT-914xx, for the
list and description of the trunk parameters and the default values.
To modify a trunk configuration, take these 5 steps with the MIB
elements located under the following path:
..\tgConfig\tgTrunk/tgTrunkTable\tgTrunkEntry
1. Lock the configured MIB section by setting the tgTrunkActionType = lock. As a
result:
When working with a MIB browser, a trunk Table of all gateway trunks is
displayed.
Select the appropriate specific trunk number.
2. Modify one of trunk's parameters, which have read-write access.
For example, the obvious parameters that can be changed:
tgTrunkType to select E1/T1/J1 type.
tgTrunkFramingMethod - to modify the framing type of the trunk.
tgTrunkLineCode - to modify the line coding of the trunk.
3. Verify the performed operation by reading the appropriate parameter.
4. Unlock the locked section by setting the tgTrunkActionType = unlock.
When working with a MIB browser, a trunk Table of all gateway trunks is
displayed.
Select a specific trunk number.
When these actions are complete, the specific trunk is configured with appropriated
settings. All other trunk parameters are configured with the default values. Refer to the
Programmer's User Manual, Document#: LTRT-914xx, for the list and description of
the board parameters and the default values.
5. Check the trunk status by examining the moOperativeStateChange alarm, which
indicates AlarmSource = modified trunk# and ProbableCause = enabled or
disabled.
(Refer to 'List of Alarms' on page 181, or the Programmer's User Manual,
Document#: LTRT-914xx, for the Alarm values.)
204 Installation & Operation Manual