>>> Copy Project/Downloads/baseinifile_files/RedundantTP1610.ini
file to /tftpboot/RedundantTP1610.ini ...
>>> Copy Project/Downloads/cmp_files/TPTPM*.cmp files to
/tftpboot ...
>>> Copy Project/Downloads/baseinifile_files/TPTPM.ini file to
/tftpboot/TPTPM.ini ...
>>> Copy Project/Downloads/baseinifile_files/NormalTPTPM.ini
file to /tftpboot/NormalTPTPM.ini ...
>>> Copy Project/Downloads/baseinifile_files/RedundantTPTPM.ini
file to /tftpboot/RedundantTPTPM.ini ...
>>> Copy Project/Downloads/dat_files/* file to /tftpboot ...
>>> Backup original versions of /tftpboot files ...
**********************************************************
* NOTE: In order to configure OAM VLAN, run 'tools vlan' *
*
script on Active SC after reboot.
**********************************************************
**************************************
* IF CONFIGURATION IS DONE OK
* YOU MUST REBOOT THE SC !!!!!!!!!!! *
**************************************
Even though this configuration is for a Simplex configuration, where only one SC
board is present, the following is displayed:
IMPORTANT: If you have second SC, DO NOT REBOOT this SC until
installation
15. You are prompted to reboot. Enter y or accept the default setting to do so.
Do REBOOT now (n/y)
16. You are prompted to confirm the reboot command. Enter Y or accept the default
setting to do so.
Are you sure (n/y)
14.3
Media Gateway Board Replacement Procedure
In the unlikely event of a Media Gateway board failure, the Avaya G860 Media
Gateway automatically notifies users with an alarm. Replace the failed board as soon
as possible to restore the system to its engineered configuration. Media Gateway
of second SC already done !!!
Reboot both SCs at the same time.
14. Hardware Replacement Procedures
*
[y]: y
[y]: y
Issue 1 October 2007 147
*