Table of Contents
Advertisement
4.7 Peripheral Setup
This setup is working mostly on Multi-I/O Chip (W83977F). The
options are used to change the Chipset's registers. Please be
careful while making any changes to default setting as to meet
your application need properly. The only special concern is
Onboard Serial Port 2. If you want to use the IrDA port, you
have to configure the SIR or ASKIR model in the BIOS's
Peripheral Setup's COM2; the RS-232 COM2 will be disabled.
Onboard FDC > to enable the FDC on your board. If you
set it to Auto, the BIOS will decide if the FDC should be
enabled, automatically.
Onboard Serial Port A (/B) > to specify the I/O port
address of the serial port 1(/2). If you set it to Auto, the
BIOS
will
decide
automatically.
Serial Port B Mode > to specify the mode of serial port 2.
the
correct
I/O
32
port
address,
Advertisement
Table of Contents
