IEI Technology Rocky-3702EV User Manual page 44

If you wish to turn off the power supply, please press
the ATX power switch button down for about 4 sec. To
turn ON system, simply push the button once.
B. For the
connector.
Refer to the following figures and follow the steps listed below:
Please disconnect the AC cord of the Power Supply from the
1.
AC source to prevent sudden electric surge to the board.
Connect the ATX Power Switch to the pin 9 (power button)
2.
and 19 (+5VSB) of J1 in the Rocky-P218A ISBC.
Connect the ATX Power Switch to the pin 9 (power button)
3.
and 19 (+5VSB) of J1 in the Rocky-P218A ISBC(Type A
connection)
Note : Some boards has Type B connection (through Power
Button and GND).
Connect the green cable from the cable kit to the pin 18
4.
(power ON) of J1 in the Rocky-P218A ISBC and connect the
purple cable to the pin 20 (+5VSB) of J1.
Connect the other port of the cable kit to the ATX power
5.
supply.
Plug in the AC jack to the AC source and the unit is now
6.
ready to be switched ON.
To turn OFF the power supply, please press the ATX power
7.
switch button down for about 5 sec. To turn ON the system,
simply push the button once.
(Please turn to the following page for graphic illustrations.)
backplanes
42
without ATX