Maintenance; Helpful Hints; Tool List; Maintenance Records - Stairmaster Crossrobics 1650 LE Owner's Manual

HELPFUL HINTS

Read all maintenance instructions thoroughly before beginning work. In some
cases, an assistant is required to perform the necessary tasks. All references
to the right or left side and to the front or back are made as if you were on the
machine ready to exercise. Major component names and locations are shown
in Figure 7.

TOOL LIST

The following tools are needed to perform service and maintenance:
• Torx screwdriver
• combination wrenches (sizes 7/16 - 3/4")• wonder bar (included w/ unit)
• combination pliers
• volt-ohm meter (multimeter)
• allen wrench set (sizes 5/64 - 1/4")
• shop goggles or other eye protection
• socket set or nut driver set (sizes 1/4 - 3/4" in 1/16" increments)

MAINTENANCE RECORDS

For ease of maintenance the Crossrobic
number of workouts, time between last servicing, etc. You can quickly access
any of the custom menus by pressing [LEVEL: ^], [4], [ENTER]. The console will
then display "MACHINE STATUS." Scroll through the following options:
[ SELECT ]
[ SELECT ]
[ SELECT ]
[ SELECT ]
[ SELECT ]
[ SELECT ]
[ SELECT ]
*The machine may show a few hours of use due to testing at the
manufacturing facility.
MAINTENANCE INSTRUCTIONS
" RUN HOURS
" WORKOUTS
" DISTANCE
" CONS 90211- XXX "
" CROSSROBIC "
-N/A-
" MAINT HOURS xxxx"
• phillips screwdriver
• locking pliers
• wire stripper/crimper tool
• external snap ring pliers
• torque wrench
®
console will keep track of hours,
XXXX"* 0
XXXX" 1
XXXX" 2
3
4
6
Page 33