Pedal - Stairmaster Crossrobics 1650 LE Owner's Manual

PARTS REMOVAL AND REPLACEMENT
10. Crimp a wiring lug onto each bared wire end and attach the wires to
the proper alternator terminals (see Wiring Diagram 1). Attach the
wires to the alternator case or adjusting bracket with a wire tie to
protect them from being damaged by moving parts.
11. Reconnect the power connector junction box.
12. Attach the connector at the upper end of the main cable to the
console and take a test run.
13. If the machine operates properly, these steps complete the replace-
ment procedure. If the console does not power up, check your wiring
against Wiring Diagram 1.
14. Reattach the side and weight stack covers.

PEDAL

1. Use an allen wrench and an open-end wrench to remove the two
bolts, the nuts and the washers.
2. Remove the pedal (see Figure 29).
3. To install the pedal, slide the pedal over the end of the pedal arm.
4. Reinstall the hardware, being careful not to over tighten the bolts.
PEDAL ARM
1. Remove the side cover(s).
2. Support the pedal arm and remove the pedal arm spring.
3. Remove the snap ring from the pedal arm mounting post (see Figure
33).
Page 62