5.
Remove the weight stack pin and carefully lower the top three plates
of the weight stack. Ensure the weight stack belt is seated properly in
the pulleys (see Figure 17).
6.
Reattach the covers.
WEIGHT STACK GUIDE ROD
1.
Remove the outside weight stack cover.
2.
Loosen the nuts and remove the bolts at the top of the guide rods
(see Figure 18).
3.
Pull one guide rod (only) out of the weight stack and replace it before
pulling out the other guide rod.
TO REDUCE THE RISK OF PERSONAL INJURY, NEVER PULL
MORE THAN ONE GUIDE ROD OUT OF THE WEIGHT STACK
AT ANY GIVEN TIME. REMOVING BOTH GUIDE RODS FROM THE
WEIGHT STACK MAY CAUSE THE WEIGHT STACK TO FALL.
PARTS REMOVAL AND REPLACEMENT
!
WARNING
Page 69