Set Setup Radius; Radius Service Settings - Qlogic SANbox 5000 Series Interface Manual

13 – Command Reference

Set Setup Radius

Set Setup Radius
NOTE:
Configures RADIUS servers on the switch.
Authority
Admin session
Syntax
set setup radius
Prompts you in a line-by-line fashion to configure RADIUS servers for user
account and device authentication.
configuration fields.
DeviceAuthOrder
UserAuthOrder
TotalServers
ServerIPAddress
ServerUDPPort
13-84
This command requires the Fabric Security license key. To purchase a
license key, contact your authorized maintenance provider or
authorized reseller. Use the
Table 13-20. RADIUS Service Settings
Entry
Authenticator priority for devices:
Local: Authenticate devices using only the local security
database. This is the default.
Radius: Authenticate devices using only the security data-
base on the RADIUS server.
RadiusLocal: Authenticate devices using the RADIUS server
security database first. If the RADIUS server is unavailable,
then use the local switch security database.
Authenticator priority for user accounts:
Local: Authenticate users using only the local security data-
base. This is the default.
Radius: Authenticate users using only the security database
on the RADIUS server.
RadiusLocal: Authenticate users using the RADIUS server
security database first. If the RADIUS server is unavailable,
then use the local switch security database.
Number of RADIUS servers to configure during this session.
Setting TotalServers to 0 disables all RADIUS authentication.
The default is 0.
IP address of the RADIUS server. The default is 10.0.0.1.
User Datagram Protocol (UDP) port number on the RADIUS
server. The default is 1812.
Feature command to install a license key.
Table 13-20 describes the RADIUS server
Description
S
59183-01 A