Show Switch; Switch Operational Parameters - Qlogic SANbox 5000 Series Interface Manual

A

Show Switch

Displays switch operational information.
Authority
None
Syntax
show switch
Notes
Table 13-27
SymbolicName
SwitchWWN
BootVersion
CreditPool
DomainID
FirstPortAddress
FlashSize - MBytes
LogFilterLevel
MaxPorts
NumberOfSwitchResets
ReasonForLastReset
ActiveImageVersion - build date
PendingImageVersion - build date
ActiveConfiguration
AdminState
AdminModeActive
Beacon
OperationalState
59183-01 A
describes the switch operational parameters.
Table 13-27. Switch Operational Parameters
Parameter Description
Descriptive name for the switch
Switch world wide name
PROM boot version
Number of port buffer credits available to recipient
ports
Switch domain ID
FC address of switch port 0
Size of the flash memory in megabytes
Event severity level used to record events in the
event log
Number of ports available on the switch
Number of times the switch has been reset over its
service life
Action that caused the last reset
Active firmware image version and build date.
Firmware image version and build date that is
pending. This image will become active at the next
reset or power cycle.
Name of the switch configuration that is in use.
Switch administrative state
Admin session status
Beacon status as set by the Set Beacon com-
mand.
Switch operational state
13 – Command Reference
Show Switch
13-141