Qlogic SANbox 5000 Series Interface Manual page 175

A
switch
Resets the switch without a power-on self test. This is the default. This reset
disrupts traffic and does the following:
Activates the pending firmware.
Closes all management sessions.
Clears the event log. To save the event log before resetting, refer to the
"Set Log" command on page
To reset the switch with a power-on self test, refer to the
page 13-30. To reset the switch without disrupting traffic, refer to the
command on page
NOTE:
system
Resets the system configuration settings to the factory default values as
described in
NOTE:
zoning
Clears the zoning database and deactivates the active zone set. The zoning
configuration parameters (InteropAutoSave, DefaultZone, DiscardInactive) remain
unchanged. Refer to
parameters.
59183-01 A
13-33.
The following files are deleted from the switch during a switch
reset:
Firmware image files that have not been unpacked
Configuration backup files
Support files
Table 13-12.
Because this keyword changes network parameters, the
workstation could lose communication with the switch.
This keyword does not affect installed license keys.
Table 13-8 for information about the zoning configuration
13-76.
"Hardreset" command on
13 – Command Reference
Reset
"Hotreset"
13-45