Date - Qlogic SANbox 5000 Series Interface Manual

A

Date

Displays or sets the system date and time. To set the date and time the
information string must be provided in this format: MMDDhhmmCCYY. The new
date and time takes effect immediately.
Authority
Admin session except to display the date.
Syntax
date
[MMDDhhmmCCYY]
Keywords
[MMDDhhmmCCYY]
Specifies the date – this requires an Admin session. If you omit
[MMDDhhmmCCYY], the current date is displayed which does not require an
Admin session.
Notes
Network Time Protocol (NTP) must be disabled to set the time with the Date
command. Enter the
NTPClientEnabled parameter.
When setting the date and time on a switch that is enabled for SSL connections,
the switch time must be within 24 hours of the workstation time. Otherwise, the
connection will fail.
Examples
The following is an example of the Date command:
SANbox #> date
Mon Apr 07 07:51:24 200x
59183-01 A
Set Setup System command to disable the
13 – Command Reference
Date
13-13