Resetting The Zoning Database; Removing Inactive Zone Sets, Zones, And Aliases - Qlogic SANbox 5000 Series Interface Manual

7 – Zoning Configuration

Resetting the Zoning Database

7.4
Resetting the Zoning Database
There are two ways to remove all aliases, zones, and zone sets from the zoning
database:
Enter the
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning) #> zoning clear
SANbox (admin-zoning) #> zoning save
Enter the
security configuration values, AutoSave, DefaultZone, and DiscardInactive
remain unchanged. This is the preferred method.
SANbox #> admin start
SANbox (admin) #> reset zoning
7.5

Removing Inactive Zone Sets, Zones, and Aliases

Enter the
database except those in the active zone set.
SANbox #> admin start
SANbox (admin) #> zoning delete orphans
This command will remove all zonesets, zones, and aliases
that are not currently active.
Please confirm (y/n): [n] y
SANbox (admin) #> zoning save
7-12
Zoning Clear command as shown in the following example:
Reset Zoning command as shown in the following example. The
Zoning Delete Orphan command to delete all objects from the zoning
S
59183-01 A