Hardware Information; Heartbeat Led Activity - Qlogic SANbox 5000 Series Interface Manual

A
5.1.5

Hardware Information

Enter the
including fans, power supplies, internal temperature, and Heartbeat LED status.
The following is an example of the Show Chassis command for model 5602:
SANbox #> show chassis
Chassis Information
-------------------
BoardTemp (1) - Degrees Celsius
FanStatus (1)
FanStatus (2)
FanDirection (1)
FanDirection (2)
PowerSupplyStatus (1)
PowerSupplyStatus (2)
HeartBeatCode
HeartBeatStatus
The HeartBeatCode and HeartBeatStatus entries indicate the Power-on Self Test
(POST) results revealed by the Heartbeat LED blink patterns. The result is normal
operation or a blink pattern indicating a critical error as described in
Refer to your Installation Guide for more information about the Heartbeat LED and
its blink patterns.
HeartBeatCode–HeartBeatStatus
1–Normal
2–AppDied
3–PostFailed
4–CorruptFilesystem
5–Overheating
59183-01 A
Show Chassis command to display the status of the switch hardware
Table 5-1. Heartbeat LED Activity
Displaying Switch Information
36
Good
Good
BackToFront
BackToFront
Good
Good
1
Normal
Description
One blink per second–Normal operation
Two blink cluster–Internal firmware failure
Three blink cluster–Fatal POST error
Four blink cluster–Configuration file system error
Five blink cluster– Over temperature
5 – Switch Configuration
Table 5-1.
5-7