Qlogic SANbox 5000 Series Interface Manual page 298

13 – Command Reference
Zoning
restore
Restores the volatile zoning database with the contents of the non-volatile zoning
database. If the InteropAutoSave parameter is False (see
use this keyword to revert changes to the volatile zoning database that were
propagated from another switch in the fabric through zone set activation or
merging fabrics.
save
Saves changes made during the current Zoning Edit session. The system informs
you that the zone set must be activated to implement any changes. This does not
apply if you entered the Zoning Clear command during the Zoning Edit session.
Examples
The following is an example of the Zoning Edit command:
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning) #>
.
.
SANbox (admin-zoning) #> zoning cancel
Zoning edit mode will be canceled.
SANbox (admin) #> admin end
13-168
Table
Please confirm (y/n): [n]
S
13-8), you can
y
59183-01 A