Qlogic SANbox 5000 Series Interface Manual page 205

A
Examples
The following is an example of the Set Config Zoning command.
SANbox #> admin start
SANbox (admin) #> config edit
The config named default is being edited.
SANbox (admin-config) #> set config zoning
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list press 'q'
or 'Q' and the ENTER key to do so.
InteropAutoSave
DefaultZone
DiscardInactive
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
59183-01 A
(True / False) [True ]
(True / False) [True ]
(True / False) [False]
13 – Command Reference
Set Config Zoning
13-75