Modifying The Zoning Database - Qlogic SANbox 5000 Series Interface Manual

A
7.3

Modifying the Zoning Database

To modify the zoning database, you must open an Admin session with the
Start command. An Admin session prevents other accounts from making changes
at the same time through Telnet, Enterprise Fabric Suite 2007, or another
management application. You must also open a Zoning Edit session with the
Zoning Edit command. The Zoning Edit session provides access to the Zoneset,
Zone, Alias, and
zoning database.
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning)#> zoneset . . .
SANbox (admin-zoning)#> zone . . .
SANbox (admin-zoning)#> alias . . .
SANbox (admin-zoning)#> zoning . . .
When you are finished making changes, enter the Zoning Save command to save
the changes and close the Zoning Edit session.
SANbox (admin-zoning)#> zoning save
To close the Zoning Edit session without saving changes, enter the Zoning Cancel
command.
SANbox (admin-zoning)#> zoning cancel
Changes to the active zone set do not take effect until you activate it with the
Zoneset Activate command. The active zone set is propagated throughout the
fabric.
SANbox (admin)#> zoneset activate zoneset_1
SANbox (admin)#> admin end
The Admin End command releases the Admin session for other administrators
when you are done making changes to the switch.
To remove all zoning database objects (aliases, zones, and zone sets) and restore
the zoning database to its factory state, enter the
shown in the following example:
SANbox (admin) #> reset zoning
59183-01 A
Zoning commands with which you make modifications to the
7 – Zoning Configuration
Modifying the Zoning Database
Reset Zoning command as
Admin
7-11