Start A Print - 3D Systems BFB-3000 Manual

BFB-3000 Set Up and Operations Manual
6.10

Start a print

Make sure all items below have been checked. This is essential to guarantee that the print
works.
 Check the bed is clear of any build material (page 13)
 Check the bed is fitted correctly (page 12)
 Check the hot-end nozzles are clean from plastic debris (page 20)
 Check the bed is level (page 21)
 Check the bed is referenced to the extruder nozzles (page 28)
 Load the extruders (page 31)
After the machine is setup correctly you will need to run two test files, documented in the
following sections. When asked to print a file you will need to follow the procedure below:
 Insert the SD card into the BFB-3000 control box.
 Turn the control box on.
 Select "Run file", and press Enter:
The first 8
characters of
the filename
will be
displayed here.
If the filename
is longer than 8
characters only
the first 6
characters of
the filename
will be
displayed on
the control box.
 Press Enter to confirm, and start the print.
Document No: D100253
> RUN FILE
EXTRUDER MAPPING
MANUAL MOVE
EXTRUDER CONTROL
HOME TOOL HEAD
SETTINGS
Current file:
FILENAME.BFB
File 3 of 3
The most
recently saved
file will appear
first. Use the Y
buttons to
scroll through
the BFB files
saved in the
root of the SD
card.
40