Perfect The Raft - 3D Systems BFB-3000 Manual

BFB-3000 Set Up and Operations Manual
6.11.4

Perfect the raft

If analysis of the raft check file yields any problems, you will need to re-examine some of
the setup stages:
ERROR
Nozzle too high
Nozzle to low
Nozzle heights appear inconsistent across a
single print
Track ripping
Purge deposit
Document No: D100253
CORRECTIVE ACTION
See "Check the bed is referenced to the
extruder nozzles" (page 28) to adjust the
height at which the nozzle starts printing.
See "Check the bed is referenced to the
extruder nozzles" (page 28) to adjust the
height at which the nozzle starts printing.
Check the bed is level (page 21).
Check the hot-end nozzles are clean
(page 20).
Check the hot-end nozzles are clean
(page 20).
46