Print The Raft Check File - 3D Systems BFB-3000 Manual

BFB-3000 Set Up and Operations Manual
6.11.1

Print the raft check file

To make sure your printer is correctly setup, you will need to print the raft check file. This
file is already included on the SD card supplied in your toolkit.
 Make sure materials are loaded as per "Load the filament" (page 31).
 Follow the section "Start a print" (page 40) to print the preloaded raft check file (on
the SD card supplied in your toolkit) relevant to the material loaded into Extruder 1
(see table below). Remember, only the first 6 characters of the filename will be
displayed on the control box if the filename is longer than 8 characters.
 Examine each raft pad in the check file, as guided in the following section.
 Remove the raft print when complete.
Document No: D100253
Material type in Extruder 1
ABS
PLA
File to print
RaftABS_CheckFile
RaftPLA_CheckFile
43