Handling Snapped Filament In The Delivery Tube - 3D Systems BFB-3000 Manual

BFB-3000 Set Up and Operations Manual
9.5.5

Handling snapped filament in the delivery tube

If filament snaps in more than one place in the delivery tube, the tube needs to be flushed
of any trapped broken sections before the filament can be reloaded.
Broken section
of filament
Remove all readily-
available sections of
filament
 Also remove filament from extruder end, as per "Handling a ground-out filament",
page 64.
Document No: D100253 66