Extruder Control - 3D Systems BFB-3000 Manual

BFB-3000 Set Up and Operations Manual
6.9.2

Extruder control

 Make sure all extruders are loaded.
 Use 'Manual move' (page 18) to move the extruders to the centre of the machine,
and lower the bed. This makes it easy to clean any purged material.
 On the control panel select the 'Extruder control' function and press enter:
 'Extruder control' manages one extruder at a time (E1, E2 or E3) using the buttons on
the control panel.
E1, E2 or E3 are
selected using
the Z buttons
">" indicates
selected extruder
Temperature
at extruder
nozzle (°C)
Document No: D100253
RUN FILE
EXTRUDER MAPPING
MANUAL MOVE
> EXTRUDER CONTROL
HOME TOOL HEAD
SETTINGS
EXTRUDER CONTROL
Cur
E3
E2 25C
> E1 259C * 260C
*
" " indicates
extruder is being
heated.
Tgt RPM
0C 0
0
Target
temperature
at extruder
nozzle (°C).
Use Y buttons
to change.
Revolutions per
minute for the
extruder drive
screw. Use X
buttons to
change.
Extruder motor
will not turn until
target
temperature has
been achieved.
37