Adjusting The Position Of The Inset Screen - Roland VR-5 Owner's Manual

3.
Select the channel for the inset screen.
Press a [SUB VIDEO SELECT] button to select the channel for displaying inside the inset screen. Pressing a button makes it light up,
and the inset screen is displayed.
Applying an effect (MIX or WIPE) for switching the channel of inset screen is not possible. The switching is made using a cut.
fig.PinP-button.eps
4.
Make the inset screen disappear.
Press the button you selected in step 2 again. The button goes dark and the inset screen disappears.
The duration of the fade when the inset screen appears or disappears is the duration set for transition effects. By default, this is set at 0.5 seconds.
You can use the menus to change the time. Refer to "Menu Operations and Menu List" (p. 60), "VIDEO MIX Menu > TRANSITION SETUP >
TRANSITION TIME" (p. 63).
Adjusting the Position and Size of the Inset Screen
You can use the touch panel for the OUTPUT MONITOR to adjust the position of the inset screen. Display the inset screen, then
slide your finger over the surface of the touch panel.
fig.move-inset-screen.eps
You can also adjust size of the inset screen. When you adjust size of the inset screen, keep touching the inset screen on OUTPUT
MONITOR and turn the [VALUE] dial.
fig.PinP-size.eps
Compositing the Video
35