Page 2
LAN/RS-232 Command Reference The VR-400UHD support two types of remote-interface communication: LAN and RS-232. Using the LAN port or RS-232 connector to send specific commands to the VR-400UHD from a controlling device lets you operate the VR-400UHD remotely. LAN Interface Command Format This uses the LAN port on the VR-400UHD.
Page 3
LAN/RS-232 Command Reference List of Commands * When sending a sequence of commands to the unit from a controller, after each one, be sure to verify that an “ack” response is returned before sending the next command. * The network and password settings must be configured beforehand. When connecting, enter the password you already set. Item Sent command Response command Parameter...
Need help?
Do you have a question about the VR-400UHD and is the answer not in the manual?
Questions and answers