Xerox CopyCentre C123 User Manual page 327

Code
016-702
016-703
016-704
016-705
016-706
016-707
016-708
016-710
016-711
016-985
016-716
016-721
016-728
016-729
016-731
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 User Guide
PCL print data could not be processed as there was insufficient space in the
print page buffer. Take one of the following actions.
• Lower the resolution in the print driver.
• Increase the size of the print page buffer.
• Add memory.
An e-mail specifying a non-registered or invalid mailbox number was received.
Take one of the following actions.
• Register the mailbox with the specified number.
• Send an e-mail to a valid mailbox.
The hard disk ran out of space because the mailboxes are full. Delete
unnecessary documents from the mailboxes.
The document could not be saved for Secure Print because the optional hard
disk is not installed. The hard disk is required to use the Secure Print feature.
The hard disk ran out of space because the maximum number of users for
secure printing was exceeded. Delete unnecessary documents or users
registered for the Secure Print feature.
Sample prints cannot be made because the hard disk is malfunctioning. Contact
the Xerox Welcome Center.
[Annotation] cannot be made because the hard disk is malfunctioning. Delete
unnecessary documents from the disk.
Delayed prints cannot be made because the hard disk is malfunctioning.
Contact the Xerox Welcome Center.
The e-mail size exceeds the maximum value allowed. Try one of the following
procedures and resend the e-mail.
• Reduce the number of pages in the document.
• Lower the resolution in [Scan Resolution].
• Reduce the document size using [Reduce/Enlarge].
• Increase the maximum value in [Maximum E-mail Size] using the Key
Operator access.
The TIFF file could not be spooled as the size of the file exceeded the remaining
space on disk. Increase the size of the PCL form area.
An error occurred while printing a job. The Auto Tray Switching feature was
enabled when [Auto Paper Off] is selected for all paper trays on the [Paper Type
Priority] screen. When the Auto Tray Switching feature is enabled, select a
paper type other than [Auto Paper Off] on the [Paper Type Priority] screen.
The TIFF file contains unsupported tags. Check the print data.
The TIFF file could not be printed as the number of colors and resolution of the
TIFF file exceeded the limit. Change the number of colors and resolution of the
TIFF file, and instruct it to print again.
Printing of the TIFF data stopped midway. Instruct it to print again.
Description and Remedy
Fault Codes
327