Xerox CopyCentre C123 User Manual page 175

Properties
Feature Setting items
Emulation Settings Variable X% – Allows you to specify the X% between 25 to
100%.
Up/Down Adjustment – Allows you to specify a value
between -250 and 250 mm (-9.8–9.8 inches) to adjust the
vertical position of a hard clip area.
Left/Right Adjustment – Allows you to specify a value
between -250 and 250 mm (-9.8–9.8 inches) to adjust the
horizontal position of a hard clip area.
Paper Margin – Allows you to specify a value between 0 and
99 mm for the paper margin.
Collated – Allows you to specify whether to collate the output.
Stapling – Allows you to select the stapling method.
Image Enhancement – Allows you to enable or disable
image enhancement.
Bypass Tray - Wait User – Allows you to specify whether to
enable or disable this feature when Tray 5 (Bypass) is
selected.
PCL
This page allows you to configure the settings when PCL is
enabled.
Paper Tray – Allows you to select the paper tray.
Output Size – Allows you to select the paper size.
Paper Size (Bypass) – Allows you to select the paper size for
Tray 5 (Bypass).
Output Destination – Allows you to select the destination for
your output.
Quantity – Allows you to specify the number of sets to print
between 1 and 999.
2 Sided Print – Allows you to select whether to print both
sides of paper.
Image Orientation – Allows you to select the image orientation.
Form Lines – Allows you to specify the page length (printing
area) of one page.
Font – Allows you to select the required font from the list of
fonts available.
Font Size – Allows you to specify the font size between 4.00
and 50.00 points in 0.25 point increments.
Font Pitch – Allows you to specify the font pitch between
6.00 and 24.00 points in 0.01 point increments.
Symbol Set – Allows you to select the desired symbol set
from the list of symbol sets available.
Handle CR As – Allows you to enable or disable carriage
return and line feed for the PCL mode.
Handle LF and FF As – Allows you to enable or disable
carriage return and line feed, and also carriage return and
form feed, for the PCL mode.
HexDump – Allows you to enable or disable hexadecimal
memory dump for the PCL mode.
Image Enhancement – Allows you to enable or disable
image enhancement.
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 User Guide 175