Ip Static Route Screen - ZyXEL Communications Vantage CNM 2.3 User Manual

Chapter 9 Device Network Settings
Table 119 Device Operation > Device Configuration > Network > Routing > Policy
Route > Edit (continued)
LABEL
Maximum
Bandwidth
Bandwidth
Priority
Maximize
Bandwidth
Usage
Apply
Cancel

9.11 IP Static Route Screen

Click Device Operation > Device Configuration > Network > Routing >
Static Route to open the Static Route screen. This screen displays the
configured static routes. Configure static routes to be able to use RIP or OSPF to
propagate the routing information to other routers.
Figure 135 Device Operation > Device Configuration > Network > Routing > Static
Route
306
DESCRIPTION
Specify the maximum bandwidth (from 1 to 1048576) allowed for the
route in kbps. If you enter 0 here, there is no bandwidth limitation for
the route.
If the sum of the bandwidths for routes using the same next hop is
higher than the actual transmission speed, lower priority traffic may not
be sent if higher priority traffic uses all of the actual bandwidth.
To reserve bandwidth for traffic that does not match any of the policy
routes, leave some of the interface's bandwidth unbudgeted and do not
enable Maximize Bandwidth Usage.
Enter a number between 1 and 7 to set the priority for traffic. The
smaller the number, the higher the priority. If you set the maximum
bandwidth to 0, the bandwidth priority will be changed to 0 after you
click Apply. That means the route has the highest priority and will get
all the bandwidth it needs up to the maximum available.
A route with higher priority is given bandwidth before a route with lower
priority.
If you set routes to have the same priority, then bandwidth is divided
equally amongst those routes.
Select this check box to have the ZyWALL divide up all of the interface's
unallocated and/or unused bandwidth among the policy routes that
require bandwidth. Do not select this if you want to reserve bandwidth
for traffic that does not match any of the policy routes.
Click Apply to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
Vantage CNM User's Guide