Bridge Summary - ZyXEL Communications Vantage CNM 2.3 User Manual

Table 108 Device Operation > Device Configuration > Network > Interface > VLAN >
Add/Edit (continued)
LABEL
Enable
Check Method
Check Period
Check Timeout Enter the number of seconds to wait for a response before the
Check Fail
Tolerance
Ping Default
Gateway
Ping this
address
Apply
Cancel

9.4 Bridge Summary

This screen lists every bridge interface and virtual interface created on top of
bridge interfaces. To access this screen, click Device Operation > Device
Configuration > Network > Interface > Bridge.
Figure 119 Device Operation > Device Configuration > Network > Interface > Bridge
Each field is described in the following table.
Table 109 Device Operation > Device Configuration > Network > Interface > Bridge
LABEL
#
Name
Vantage CNM User's Guide
DESCRIPTION
Select this to turn on the connection check.
Select the method that the gateway allows.
Select icmp to have the ZyWALL regularly ping the gateway you
specify to make sure it is still available.
Select tcp to have the ZyWALL regularly perform a TCP handshake
with the gateway you specify to make sure it is still available.
Enter the number of seconds between connection check attempts.
attempt is a failure.
Enter the number of consecutive failures before the ZyWALL stops
routing through the gateway.
Select this to use the default gateway for the connectivity check.
Select this to specify a domain name or IP address for the
connectivity check. Enter that domain name or IP address in the field
next to it.
Click Apply to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
DESCRIPTION
This field is a sequential value, and it is not associated with any
interface.
This field displays the name of the interface.
Chapter 9 Device Network Settings
277