Lan (Prestige) - ZyXEL Communications Vantage CNM 2.3 User Manual

Centralized network management

Hide thumbs Also See for Vantage CNM 2.3:

Table of Contents

Table 13 Device Operation > Device Configuration > LAN > LAN (ZyNOS ZyWALL)

Allow between

LAN and WAN2

Allow between

Allow between

LAN and WLAN

5.2 LAN (Prestige)

Note: This section refers only to the LAN screen, but the information is applicable for

the LAN, WLAN, and DMZ screens.

Use this screen to configure the DHCP settings, TCP/IP settings, and Any IP

settings for the LAN port on a device. To open this screen, click Device Operation

Vantage CNM User's Guide

Select this check box to forward NetBIOS packets from the LAN to

WAN port 2 and from WAN port 2 to the LAN. If your firewall is enabled

with the default policy set to block WAN port 2 to LAN traffic, you also

need to enable the default WAN port 2 to LAN firewall rule that

forwards NetBIOS traffic.

Clear this check box to block all NetBIOS packets going from the LAN

to WAN port 2 and from WAN port 2 to the LAN.

Select this check box to forward NetBIOS packets from the LAN to the

DMZ and from the DMZ to the LAN. If your firewall is enabled with the

default policy set to block DMZ to LAN traffic, you also need to enable

the default DMZ to LAN firewall rule that forwards NetBIOS traffic.

Clear this check box to block all NetBIOS packets going from the LAN

to the DMZ and from the DMZ to the LAN.

Select this check box to forward NetBIOS packets from the LAN to the

WLAN and from the WLAN to the LAN.

Clear this check box to block all NetBIOS packets going from the LAN

to the WLAN and from the WLAN to the LAN.

Click this to save your changes back to the device.

Click this to begin configuring this screen afresh.

Chapter 5 Device Network Settings