Ethernet Edit - ZyXEL Communications Vantage CNM 2.3 User Manual

Centralized network management

Hide thumbs Also See for Vantage CNM 2.3:

Table of Contents

Chapter 9 Device Network Settings

Table 96 Device Operation > Device Configuration > Network > Interface > Ethernet

(ZLD ZyWALL) (continued)

9.1.1 Ethernet Edit

Use this screen to configure IP address assignment, interface parameters, RIP

settings, OSPF settings, DHCP settings, and connectivity check settings. To access

this screen, click an Edit icon next to an interface in the Device Operation >

Device Configuration > Network > Interface > Ethernet screen.

This field displays the current IP address of the interface. If the IP

address is 0.0.0.0, the interface does not have an IP address yet.

This screen also shows whether the IP address is a static IP address

(STATIC) or dynamically assigned (DHCP). IP addresses are always

static in virtual interfaces.

This field displays the interface's subnet mask in dot decimal notation.

This column lets you create, edit, or remove interfaces. You cannot add

or remove Ethernet interfaces, however.

To create a virtual Ethernet interface, click the Add icon next to the

corresponding Ethernet interface.

To edit an interface, click the Edit icon next to it.

To remove a virtual interface, click the Remove icon next to it. The

ZyWALL confirms you want to remove it before doing so.

Make sure you click Apply to save and apply the change.

Vantage CNM User's Guide