Chapter 7 Device Advanced Settings
7.2 Port Forwarding
Use this screen to configure port forwarding on the device. To open this screen,
click a device, click Device Operation in the menu bar, and then click Device
Configuration > Advanced > NAT > Port Forwarding in the navigation panel.
Figure 87 Device Operation > Device Configuration > Advanced > NAT > Port
Forwarding
The following table describes the labels in this screen.
Table 80 Device Operation > Device Configuration > Advanced > NAT > Port
Fowarding
LABEL
WAN Interface
#
Active
Name
Default Server
All Ports
Incoming
Port(s) (start/
end)
218
DESCRIPTION
Select the WAN port to use the port forwarding rules.
This is the number of an individual entry.
Select this check box to enable the port forwarding entry. Clear this
check box to disallow forwarding of these ports to an inside server
without having to delete the entry.
Type a name to identify this port-forwarding rule. To delete a port
forwarding entry, erase the name, and click Apply.
In addition to the servers for specified services, NAT supports a default
server. A default server receives packets from ports that are not specified
in this screen. If you do not assign a default server IP address, then all
packets received for ports not specified in this screen or remote
management will be discarded.
Enter a port number here. To forward only one port, enter it again in the
second field. To specify a range of ports, enter the last port to be
forwarded in the second field.
Vantage CNM User's Guide