Chapter 5 Device Network Settings
Table 28 Device Operation > Device Configuration > Network > WAN > Dial Backup
> Edit – ZyNOS ZyWALL (continued)
LABEL
RIP Version
Apply
Reset
5.3.7 WAN Setup (Prestige)
The fields in this screen vary depending on device mode and the encapsulation
you select. To open this screen, select a device, click Device Operation in the
102
DESCRIPTION
The RIP Version field controls the format and the broadcasting
method of the RIP packets that the device sends (it recognizes both
formats when receiving). RIP-1 is universally supported but RIP-2
carries more information. RIP-1 is probably adequate for most
networks, unless you have an unusual network topology. Both RIP-
2B and RIP-2M sends the routing data in RIP-2 format; the
difference being that RIP-2B uses subnet broadcasting while RIP-
2M uses multicasting. Multicasting can reduce the load on non-
router machines since they generally do not listen to the RIP
multicast address and so will not receive the RIP packets. However,
if one router uses multicasting, then all routers on your network
must use multicasting, also. By default, RIP direction is set to Both
and the Version set to RIP-1.
Click this to save your changes back to the device.
Click this to begin configuring this screen afresh.
Vantage CNM User's Guide