Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for ZyXEL Communications NetAtlas Workgroup
Summary of Contents for ZyXEL Communications NetAtlas Workgroup
-
Page 1: Quick Start Guide
NetAtlas Workgroup Ethernet Switch Manager Quick Start Guide Version 1.03 Edition 1 1/2007... -
Page 2: Minimum System Requirements
SNMP protocol. The EMS allows you to manage multiple switches from a central location. This guide shows you how to install NetAtlas Workgroup. Refer to the user’s guide for background and configuration information. 2 Minimum System Requirements •... - Page 3 NetAtlas Workgroup Quick Start Guide 3 Install EMS Server Follow the steps below to install the EMS server on a computer. Note: Follow the directions in the wizard to proceed through the installation. Only screens that require input specific to the EMS Workgroup installation are shown.
- Page 4 NetAtlas Workgroup Quick Start Guide 5 You can set the SNMPc to automatically locate your ZyXEL switch(es). Specify the IP address, subnet mask and community (or password) of a device as the starting point. Make sure the IP address and subnet mask of this device and your ZyXEL switch are in the same range.
- Page 5 NetAtlas Workgroup Quick Start Guide 9 Specify the installation options. Make sure you install in the same file location as specified in Click Next to continue. 10 Accept the default or specify the account user name and password that allows the PostgreSQL to run on your computer.
- Page 6 NetAtlas Workgroup Quick Start Guide 13 Accept the default setting and click Next to continue. 14 Select additional function(s) for the database. Note: Do NOT clear the DBsize or pgAdmin Support option. Continue through the installation and click Finish when you get to the final PostgreSQL screen.
-
Page 7: Compile Mibs
NetAtlas Workgroup Quick Start Guide 4 SNMPc Network Manager Startup To start the SNMPc Network Manager manually, use the Windows Start menu. To start SNMPc automatically each time you turn on your computer, click Config, System Startup, select Auto Startup and then click OK. -
Page 8: Device Auto-Discovery
NetAtlas Workgroup Quick Start Guide 6.1 Device Auto-Discovery 1 To enable auto-discovery and then find your device, click Config, Discovery/Polling. 2 Select the Enable Discovery check box and click OK. 3 Find your device in the Device List panel. Double-click the device icon to access the EMS. - Page 9 NetAtlas Workgroup Quick Start Guide Note: For security purposes, it is strongly recommended you change the Read Community and Read/Write Community defaults and store this information in a secure place so you will not forget it later. 5 After the device has been found, an icon and label appear in the network manager view window.
-
Page 10: Troubleshooting
NetAtlas Workgroup Quick Start Guide 7.1 Database Synchronization If you upgrade EMS from a previous version, the Database Synchronization screen displays when you try to access the EMS. You can use this screen to back up the database from a previous EMS version using the new database format. - Page 11 NetAtlas Workgroup Quick Start Guide • Remove any previous versions of PostgreSQL from your com- puter. See Step • Re-install PostgreSQL and EMS in that order. See 2 I cannot find my device in the SNMPc Management screen. • Check that you have compiled the MIBs without errors (see tion 5 on page •...
- Page 12 NetAtlas Workgroup Quick Start Guide Configure the ODBC Driver The ODBC driver should already be installed during the EMS installation process. If you have changed the default ODBC settings, make sure the EMS can connect to the PostgreSQL database successfully.
Need help?
Do you have a question about the NetAtlas Workgroup and is the answer not in the manual?
Questions and answers