Edit A Static Route - ZyXEL Communications Vantage CNM 2.3 User Manual

Centralized network management

Hide thumbs Also See for Vantage CNM 2.3:

Table of Contents

Chapter 7 Device Advanced Settings

7.6.1 Edit a Static Route

Use this screen to edit a static route in the device. To open this screen, select a

static route, and click Edit in the Device Operation > Device Configuration >

Advanced > Static Route screen.

Figure 93 Device Operation > Device Configuration > Advanced > Static Route >

The following table describes the labels in this screen.

Table 86 Device Operation > Device Configuration > Advanced > Static Route >

Destination IP

IP Subnet Mask

Enter the name of the IP static route. Leave this field blank to delete

this static route.

This check box allows you to activate/deactivate this static route.

This parameter specifies the IP network address of the final destination.

Routing is always based on network number. If you need to specify a

route to a single host, use a subnet mask of 255.255.255.255 in the

subnet mask field to force the network number to be identical to the

Enter the IP subnet mask here.

Enter the IP address of the gateway. The gateway is an immediate

neighbor of the device that will forward the packet to the destination.

On the LAN, the gateway must be a router on the same segment as the

device; over the WAN, the gateway must be the IP address of one of the

Remote Nodes.

Metric represents the cost of transmission for routing purposes. IP

routing uses hop count as the measurement of cost, with a minimum of

1 for directly connected networks. Enter a number that approximates

the cost for this link. The number need not be precise, but it must be

between 1 and 15. In practice, 2 or 3 is usually a good number.

Vantage CNM User's Guide