Error Codes - Ricoh Aficio FX10 Operator's Manual

Troubleshooting Error Codes
< cl-lEcK PAPER SIZE
The size of the installed paper does not match the
currently selected paper size.
Set the paper size (see page 87) or install the appropriate
paper.
UNABLE USE PRINTER
Machine cannot print a list/file, because the heater is not
warm enough or plotter is not ready.
SERVICE CALL ¤-m~ H Machine is out of order. Contact your service
representative.
Error Codes
When an error occurs, an error report is printed, This report includes an error
code. The following table lists common error codes and a few of the possible
causes. If any of these or any other error codes are persistent and the machine
does not work properly, contact a service technician.
Note:When an error occurs, it does not mean that you are doing anything
—
wrong or that your machine needs service. Only if the problem persists
should you call your service representative.
Code
Possible Cause
0-01
Printer empty or jammed at the other end
0-04
Faulty machine at the other end
Poor line condition
0-05
Poor line condition
-0-06
Incompatible or faulty terminal at the other end
Poor line condition
0-07
The other party's machine disconnected during the call. Resend the page.
If the problem persists, contact the other party.
0-08
The machine at the other end received the page that you sent but it had
errors on the page. You may want to resend the page in question.
The other party's memory could also be full. Contact the other party and
ask them to make room in their memory for your message.
0-14
Same as for code 0-06
0-15
The other party's memory may be full.
0-16
Same as for code 0-04
0-20
Poor line condition
117