Troubleshooting; Pc-Printing - Ricoh Aficio FX10 Operator's Manual

TROUBLESHOOTING
PC-PRINTING
PC-Printin9 is not done even though the Print command was
executed.
The following causes are likely. Carry out the remedies specified for each
respective cause.
The machine's power is not on.
Turn the machine's power on so that it can function.
The cables are not connected correctly.
Connect the cables correctly.
The machine is warming up, or is performing some other operation.
Wait until the machine is finished warming up or performing the other
operation.
The cover is open.
Close the cover completely.
The machine is out of toner.
Replace the toner with a new toner cassette.
The paper is jammed.
Clear the cause of the paper jam.
The machine is out of paper.
Set paper in the machine.
The paper size setting differs from the setting in the machine and the
printer driver in the PC.
Set both paper sizes so they match.
There was a paper size error in the machine already.
Set the paper size in the machine and in the printer driver in the PC so that
they match the actual paper size.
The Auto
Receiving Mode is set in the
FAX application.
Change the setting in the FAX application to the Manual Receiving Mode.
Note:
If connected to a Macintosh using the optional serial interface, when printing
from the Macintosh, printing from a PC cannot be done. After printing from the
Macintosh is completed, execute the Print command again.
PC-Printing was suspended.
The following causes are likely. Carry out the remedies specified for each
respective cause.
113