Table of Contents
Advertisement
INSTALLATION
Before installing your machine, read the safety instructions at the beginning of
this manual. To install the machine, follow these procedures:
1-Find a suitable location for the machine.
2-Remove
all the pieces of tape attached to the machine and push the scan-
ner lock lever at the rear of the machine down (See page 135.)
3-install the ozone filter, photoconductor,
cleaning pad and toner.
(See page 136.)
4-Attach the accessories
and load the paper in the cassette. (See page 139.)
5-Connect the phone line. (See page 142.)
6-Connect the power. (See pagel 43.)
7-Enter all necessary information and settings in your machine's memory.
(See page 144.)
Machine Environment
WARNING:
When choosing a location for your machine, pIease follow the
safety instruction given on pages 2 to 7 of this manual.
Location
For the best possible
performance,
install your machine
in a place which
satisfies the following conditions.
Warning:
If you do not operate under the following condition, an accident may
occur.
u
c1
c1
c1
c1
CJ
CJ
CJ
u
c1
Not exposed to direct sunlight
Well ventilated (air turnover at least three times per hour); to avoid the
build-up of ozone, make sure to locate the machine in a large well-venti-
lated room which has an air turnover of more than 30 yd3/hr per person.
Level
Not subject to vibration
Away
from
other
electronic
equipment,
to avoid
interference
Away from areas containing corrosive gas
Dust-free
Condensation-free
Temperature
63 to 82°F
Humidity 40 to 70% RH (do not install near a humidifier)
133
Advertisement
Table of Contents
Troubleshooting
