Table of Contents
Advertisement
OfficeStyler
T1 O Configuration
Overview
INTRODUCTION
Client Configuration
The Client is a peer in the workgroup
that wants to print to another peer's
printer. The Client configuration
is a subset of the Sewer configuration
and is
provided in those cases when saving disk space at the Client is an issue.
If at some point, the PC configured
as a Client attaches
a OfficeStyler
T1 O
software
printer, that PC must re-install
the OfficeStyler
TI O software
and
select the Setver option.
Note:
Re-installation
can be via installation disks or across the network.
Server Configuration
The Server is the peer in the workgroup that has a printer connected
to it. At
installation, the OfficeStyler
TI O Set-up Program asks if you wish to configure
the PC as a Server or a Client. You must configure the PC with the attached
OfficeStyler
T1 O software printer as a Server.
Note:
If you previously
installed
and configured
your PC as a Client,
you must
reinstall your printer as a Server. You can either use your installation disks or
install across the network if there is another Setver configured and running.
Any Server in the workgroup
with OfficeStyler
T1 O software installed can be
effectively
both a Server
and a Client.
As a Server,
that PC shares
the
connected
printer with other peers in the workgroup.
However,
when that
server opts to print to a printer supported by another Server, that PC is acting
as a Client to the other Server.
Advertisement
Table of Contents
Troubleshooting
