Throttle Lubrication; Throttle Grip Free Play Adjustment Steps - Yamaha WR426F(P) Owner's Service Manual

2

THROTTLE LUBRICATION

2. Adjust:
Throttle grip free play
G

Throttle grip free play adjustment steps:

Remove the throttle cable cap 1 and
G
throttle cable cover 2.
1
NOTE:
Before adjusting the throttle cable free
G
play, the engine idle speed should be
adjusted.
When the motorcycle is accelerating,
G
throttle cable #1 3 is pulled and throttle
cable #2 4 is pushed.
1st step:
Loosen the locknuts 5 on throttle cable #2.
G
Adjust the free play by changing their
G
tightening position.
2nd step:
Loosen the locknuts 6 on throttle cable #1.
G
Adjust the free play by changing their
G
tightening position.
Tighten the locknuts.
G
WARNING
After adjusting, turn the handlebar to
right and left and make sure that the
engine idling does not run faster.
Install the throttle cable cover and throttle
G
cable cap.
THROTTLE LUBRICATION
1. Remove:
Cover (throttle cable cap) 1
G
Cover (grip cap) 2
G
Throttle cable cap 3
G
2. Apply:
Lithium soap base grease
G
On the throttle cable end a.
3. Install:
Throttle cable cap
G
Screw (throttle cable cap)
G
Cover (grip cap)
G
Cover (throttle cable cap)
G
3 - 11
INSP
ADJ
4 Nm (0.4 m · kg, 2.9 ft · lb)