Yamaha WR426F(P) Owner's Service Manual page 644

2
1
B
HANDLEBAR
8. Install:
Master cylinder 1
G
Master cylinder bracket 2
G
Bolt (master cylinder bracket) 3
G
NOTE:
Install the bracket so that the arrow mark a
G
faces upward.
First tighten the bolt on the upper side of the
G
master cylinder bracket, and then tighten the
bolt on the lower side.
9. Install:
Lights switch 1
G
10. Install:
"ENGINE STOP" button 1
G
Clutch lever holder 2
G
Bolt (clutch lever holder) 3
G
Decompressor lever holder 4
G
Bolt (decompressor lever holder) 5
G
Clamp 6
G
NOTE:
The "ENGINE STOP" button, clutch lever
G
holder, decompression lever holder and
clamp should be installed according to the
dimensions shown.
Pass the "ENGINE STOP" button lead in the
G
middle of the clutch holder.
11. Install:
Clutch cable 1
G
Decompression cable 2
G
NOTE:
Apply the lithium soap base grease on the
clutch cable end and decompression cable
end.
5 - 45
CHAS
9 Nm (0.9 m · kg, 6.5 ft · lb)
2 Nm (0.2 m · kg, 1.4 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)