Yamaha WR426F(P) Owner's Service Manual page 516

1
2
CDI MAGNETO
4. Connect:
CDI magneto lead
G
Refer to "CABLE ROUTING DIA-
GRAM" section in the CHAPTER 2.
5. Install:
Gasket [crankcase cover (left)]
G
Crankcase cover (left) 1
G
Hose holder (cylinder head breather
G
hose) 2
Bolt [crankcase cover (left)]
G
NOTE:
Tighten the bolts in stage, using a crisscross
pattern.
6. Install:
Shift pedal 1
G
Bolt (shift pedal)
G
NOTE:
When installing the shift pedal onto the shift
shaft, be sure that the center of the shift pedal
is about 2 mm a above the top of the footrest.
7. Install:
Engine guard (left) 1
G
Hose holder (cylinder head breather
G
hose) 2
Bolt [engine guard (left)]
G
4 - 87
ENG
New
10 Nm (1.0 m · kg, 7.2 ft · lb)
23 Nm (2.3 m · kg, 17 ft · lb)