Removing The Touch Pad/Fingerprint Sensor Board - Toshiba TECRA M10 Maintenance Manual

4 Replacement Procedures
4 Replacement Procedures
4.27 Touch pad/Fingerprint sensor board

Removing the Touch pad/Fingerprint sensor board

To remove the touch pad/fingerprint sensor board, follow the steps below and refer to Figure
4-49 to 4-52.
1. Turn up the insulator (TPAD PLT INSULATOR) and remove the following screws.
•
M2.5×4B
2. Peel off the insulator (SQUARE INSULATOR).
Insulator
(SQUARE INSULATOR)
M2.5x4B FLAT HEAD
Insulator
(TPAD PLT INSULATOR)
Figure 4-49 Removing the touch pad/fingerprint sensor board (1)
4-78 [CONFIDENTIAL]
FLAT HEAD screw
4.27 Touch pad/Fingerprint sensor board
×4
M2.5x4B FLAT HEAD
Insulator
(TPAD PLT INSULATOR)
TECRA M10 Maintenance Manual (960-685)