Installing The System Board - Toshiba TECRA M10 Maintenance Manual

Hide thumbs Also See for TECRA M10:

Table of Contents

4.20 System board

Installing the System board

To install the system board, follow the steps below and refer to Figure 4-36 to 4-37.

1. Connect the DC-IN harness and HDD harness to the connector CN8800 and

CN1900 on the back of the system board.

2. Set the system board in place and secure it with the following screw(s).

3. Set the DC-IN jack into the slot.

4. Connect the sound board FFC to the connector CN9530 on the system board and

stick the glass tape in place.

TECRA M10 Maintenance Manual (960-685)

Tapping screw

4 Replacement Procedures

[CONFIDENTIAL]

Show Quick Links

Table of Contents