Removing The Cpu/Cpu Fin/Dc Fan - Toshiba TECRA M10 Maintenance Manual

4.22 CPU/CPU fin/DC fan
4.22 CPU/CPU fin/DC fan

Removing the CPU/CPU fin/DC fan

To remove the CPU/CPU fin/DC fan, follow the steps below and refer to Figure 4-40 to 4-42.
1. Disconnect the fan harness from the connector CN8771 on the system board.
2. Remove the following screws and heat sink plate.
•
M2.0×4B
3. Remove the following screws and CPU fin (with the DC fan).
•
M2.0×4B
NOTE: When removing the heat sink plate and CPU fin, be sure to remove the screws in
the reverse order of the number marked (4 to 1 and 2 to 1) on the heat sink plate
and board spring of the CPU fin.
Heat sink plate
M2.0x4B BIND
TECRA M10 Maintenance Manual (960-685)
BIND screw
BIND screw
CPU fin
CN8771
Figure 4-40 Removing the CPU fin/DC fan (1)
4 Replacement Procedures
×4
×2
M2.0x4B BIND
Board spring
M2.0x4B BIND
[CONFIDENTIAL]
Fan harness
4-65