Removing The Hdd; Removing The Hdd Assembly - Toshiba TECRA M10 Maintenance Manual

4 Replacement Procedures
4.7 HDD

Removing the HDD

To remove the HDD, follow the steps below and refer to Figure 4-10 and 4-11.
CAUTION: Take care not to press on the top or bottom of a HDD. Pressure may cause the
data loss or damage to the device.
1. Remove the following screw securing the HDD cover.
•
M2.5×5B
2. Insert your finger into the slot and lift the HDD cover to remove.
3. Remove the HDD assembly from the slot and disconnect it from the connector on the
HDD harness.
M2.5×5B FLAT HEAD
HDD assembly
4-22 [CONFIDENTIAL]
FLAT HEAD screw
Slot
Figure 4-10 Removing the HDD assembly
×1
HDD cover
HDD harness
TECRA M10 Maintenance Manual (960-685)
4.7 HDD