Toshiba TECRA M10 Maintenance Manual page 357

4.35 Fluorescent Lamp
Disassembly of Board Ass'y, Tape Adhesive, Sheets, Light guide, Cover Ass'y Bottom (L)
1. Disassembly of Board Ass'y1.
CAUTION: This process should be made in Clean room with no scratch nor particle on
Polarizer and B/L Ass'y.
2. Disassembly of Tape Adhesive2 used for Sheets fixing (4 Points).
3. Disassembly of Sheets and Light guide3.
CAUTION: No penetration of foreign body is indispensable with any scratch on the
surface of each Sheet.
4. Disassembly of Screw (2 Points) and Cover Ass'y Bottom (L)4.
CAUTION: Maximum value of torque with Screw should be below 2.5kgf.
Figure 4-83 Replacing 14.1-inch LG fluorescent lamp (WXGA+) (4)
TECRA M10 Maintenance Manual (960-685)
4 Replacement Procedures
[CONFIDENTIAL] 4-125